Airport Comparison
| DEN | SQI | |
|---|---|---|
| Airport Name | Denver International Airport | Whiteside County/Jos H Bittorf Field |
| IATA Code | DEN | SQI |
| ICAO Code | KDEN | KSQI |
| City | Denver | Sterling/Rockfalls |
| Country | United States | United States |
| Timezone | America/Denver | America/Chicago |
| Elevation | 5,434 ft | 648 ft |
| Coordinates | 39.860000, -104.670000 | 41.740000, -89.680000 |
Denver (DEN) to Sterling/Rockfalls (SQI) Flight Distance
The flight distance from Denver International Airport (DEN) in Denver, United States to Whiteside County/Jos H Bittorf Field (SQI) in Sterling/Rockfalls, United States is 1,277 kilometers (794 miles / 690 nautical miles). The estimated flight time for this route is approximately 3h, flying east northeast at a heading of 76°.
This is a short-haul route typically served by narrow-body aircraft such as the Boeing 737 or Airbus A320 family. In-flight service is usually limited to drinks and light snacks.
This is a domestic route within United States. Both airports operate in the same country, which may simplify travel requirements and documentation. Despite being a domestic route, there is a 1-hour time difference between the two cities.
Time zone information: When it's 02:31 in Denver, it's 03:31 in Sterling/Rockfalls.
There is a significant elevation difference of 4,786 feet between the two airports. Whiteside County/Jos H Bittorf Field sits lower than Denver International Airport. Travelers arriving at the higher-elevation airport should be aware of potential altitude effects.
The return flight from Sterling/Rockfalls (SQI) to Denver (DEN) follows a heading of 266° (west). Actual flight times may vary depending on wind conditions, air traffic, and the specific aircraft used.
For more information about these airports, visit the Denver International Airport (DEN) and Whiteside County/Jos H Bittorf Field (SQI) detail pages, or use our flight duration calculator to compare other routes.